
Vinyl
Application
Tips
FOR THE BEST RESULTS
Clean the area well. Alcohol does wonders! Make sure the vehicle hasn’t been sitting in the sun or too hot to the touch. (Unless using
wet application method.)
GET IT ON STRAIGHT
You can use a piece of masking tape or blue painters tape to make a straight line under (or over) where your Jeep Name will go, to help you line it up straight.
THERE IS NO RE-APPLYING
You got ONE shot, so make sure it is EXACTLY where you want it BEFORE the sticky backing of the Vinyl touches your vehicle. It will not come back off without stretching it or destroying it.
WET APPLICATION
You can spray some (slightly soapy) water on the area first if you want. Then you will be able to adjust the decal bit to get it straight. Just make sure you use the included plastic squeegee to scrape ALL the water out, and allow it to dry a bit before peeling. Peel slowly, if any parts of the decal move or don't stick to your vehicle, keep repeating the process.
See an example of
wet application in the video below.
Pro Tip
Applying your decal straight & exactly where you want it
Transfer/Peeling from Backer Paper
Getting your decal onto the transfer paper
Wet Application
Allows for a bit of repositioning.
Get Behind-the-Scenes
JEEP NAME - T-REX
JEEP NAME - PHOENIX
JEEP NAME - BORDER RAT
JEEP NAME - STORMBREAKER
JEEP HOOD DECAL - SUPERMAN 3D
JEEP HOOD DECAL - PHOENIX/RAVEN
ORACAL 851 GLITTER SPARKLE
ORACAL 851 GLITTER SPARKLE
GRAPHIC DESIGN
Wave at Us